Ford Tractor 2000, 3000, 4000, 5000 (All Purpose and LCG) Operator's Manual 1965-1975

The Ford Tractor Proof-Meter, Figure 7, is the large dial in the center of the instrument cluster. The Proof-Meter indicates:

The engine revolutions per minute. This is especially helpful in maintaining recommended power take-off (P.T.O.) speeds. Multiply the figures indicated by 100 to determine engine rpm.

The hours and portions of hours your tractor has operated, based on an average engine speed of 1500 rpm. (Engine speeds below 1500 rpm accumulate hours at a slower rate than clock hours. Engine speeds above 1500 rpm build up hours faster than clock hours.) Use the Proof-Meter to determine when to perform service and maintenance.

The Proof-Meter is used in conjunction with the ground speed charts on page 129 to determine the tractor ground speed. The Proof-Meter can also be used to determine P.T.O. speed and belt pulley speed. For further P.T.O. and belt pulley information, refer to pages 32 and 40.

The fuel tank shut-off valve, Figure 8, is located on the right-hand side of the tractor. To stop the flow of fuel from the tank, turn the valve clockwise.

Foot-operated brake pedals, Figure 9, are provided on the right side of the transmission housing. Depress the right pedal to brake the right rear wheel and the left pedal to brake the left rear wheel. To stop the tractor, depress both pedals simultaneously.

To assist in making sharp turns, at slow-to-moderate speeds, apply the right or left brake pedal as required. CAUTION: When operating the tractor at high speeds, never attempt to make sharp turns by using the brakes.

• Controls and Instruments
• Operation:
  • Pre-start Check
  • Break-in
  • Starting the Engine
  • Operating the Tractor
  • Operating the Hydraulic System
  • Attaching Implements
  • more
• Maintenance:
  • Lubrication
  • Engine
  • Mechanical
  • Steering, Wheels, Brakes and Tires
  • Electrical
  • more
• Accessories
• Specifications:
  • General
  • Capacities
  • Engine Specs
  • Cooling, Fuel, Ignition, Electrical Systems
  • Clutch
  • Transmission
  • Hydraulic System
  • Brakes
  • more