The 2006-2016 Yamaha Raptor 700R repair manual by Clymer, covers models indicated and includes information specific to Yamaha YFM700R, YFM70R, and YFM70RSE All-Terrain Vehicles.

The Clymer M290 service manual for 2006-2016 Yamaha Raptor 700R models is based on a complete teardown and rebuild of the specific ATV - refer to the above video. Technicians, writers and photographers work together to capture precise and authoritive service, maintenance and repair instructions for all components of the 700R Raptor, including: Engine, Clutch, Transmission, Fuel Injection System, Cooling System, Electrical System, Suspension, Axles, Brakes, Body and Troubleshooting. The step-by-step procedures are very easy to understand and include detailed photography to enhance overall understanding.

NOTE: This Yamaha 700R service manual includes Color Wiring Diagrams too. Pick up a copy of this outstanding DIY Clymer manual today so you can take control of the maintenance and repair tasks yourself.

Book Excerpt: 2006-2016 Yamaha Raptor 700R Repair Manual FRONT SUSPENSION AND STEERING

This chapter provides service procedures for the front suspension and steering components. Refer to the Table 1 and Table 2 at the end of this chapter for specifications. HANDLEBAR | ADJUSTMENT

1. Withdraw the fuel tank vent hose (A, Figure 1) from the handlebar cover.
2. Push up and remove the handlebar cover (B, Figure 1).
3. Loosen the rear (A, Figure 2), and then the front (B) handlebar holder bolts.
4. Tilt the handlebar to the desired position.
5. Tighten the front (B, Figure 2), and then the rear (A) handlebar holder bolts to 23 N.m (17 ft. lb.).

REMOVAL AND INSTALLATION

1. Withdraw the fuel tank vent hose (A, Figure 1) from the handlebar cover.
2. Push up and remove the handlebar cover (B, Figure 1).
3. Remove cable and hose bands.
4. Remove the front master cylinder as described in Chapter Fourteen.
5. Remove the throttle housing clamp screws (A, Figure 3), clamp (B) and throttle housing (C). Place the throttle housing out of the way.

WHEELS, TIRES AND DRIVE CHAIN

DRIVE CHAIN Refer to Chapter Three for drive chain cleaning, lubrication, adjustment and measurement. Refer to Table 3 in this chapter for drive chain specifications. When checking the condition of the chain, also check the condition of the sprockets (Chapter Three). If either the chain or sprockets are worn, replace all drive components. Using new sprockets with a worn chain, or a new chain on worn sprockets will shorten the life of the new part. The vehicle is originally equipped with an endless O-ring type chain. This type of chain is recommended because it is internally lubricated and requires minimal maintenance. The chain is permanently assembled, which increases reliability. However, to remove the chain, the swing arm must be partially disassembled so the chain can pass by the swing arm pivot.

Subject: 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016 Yamaha Raptor 700R service, maintenance, repair. ISBN-10: 1599692961 | ISBN-13: 9781620922736 | Clymer M290