Honda VF700, VF750, VF1000 Interceptor Repair Manual 1983-1985

SKU: M349

Honda VF700, VF750, VF1000 Interceptor Repair Manual 1983-1985

SKU: M349
MSRP: $49.95
Only $43.95
free shipping (US48)

in stock | item #: M349

Adding to cart… The item has been added
Usually ships the same business day

Why Buy From Us?

  • Free Shipping
  • Veteran Owned
  • Secure Shopping
  • Satisfaction Guaranteed

Honda VF700, VF750, VF1000 Interceptor Repair Manual 1983-1985

MSRP: $49.95
Only $43.95
free shipping (US48)

in stock

Adding to cart… The item has been added

The 1983-1985 Honda VF700, VF750, VF1000 Interceptor repair manual by Clymer covers:

  • Honda VF700F Interceptor, 1984-1985
  • Honda VF750F Interceptor, 1983-1984
  • Honda VF1000F Interceptor, 1984


Book Excerpt: 1983-1985 Honda VF700, VF750, VF1000 Interceptor Repair Manual ENGINE
PISTONS AND CONNECTING RODS The engine must be removed from the frame and the crankcase disassembled in order to remove the pistons and connecting rods. The pistons and connecting rods are removed through the top of the cylinder bore. PISTON AND CONNECTING ROD: REMOVAL/INSTALLATION
  1. Remove the engine as described in this chapter.
  2. Remove the cylinder heads as described in this chapter.
  3. Mark the piston crown with the corresponding cylinder number so the piston will be reinstalled in the correct cylinder. Refer to Figure 221 for cylinder numbers.
  4. CAUTION! If disassembling a well run-in engine, inspect the top of the cylinder bores for a ridge where the piston ring reaches the top of its travel (Figure 222). Perform Step 4 only if there is a ridge present.
  5. If there is a ridge at the top of any cylinder bore, the ridge must be removed with an automotive type ridge reamer.

FRONT FORK
The front suspension uses a spring controlled, hydraulically damped, telescopic fork with air assist. An anti-drive feature has been built into the left-hand fork leg and is covered separately in this chapter. Before suspecting major trouble, drain the front fork oil and refill with the proper type and quantity; refer to Front Fork Oil Change in Chapter Three. If you still have trouble, such as poor damping, a tendency to bottom or top out or leakage around the rubber seals, follow the service procedures in this section. To simplify fork service and to prevent the mixing of parts, the legs should be removed, serviced and installed individually.

The Clymer M349 repair manual is the number one source for DIY service and repair procedures for your Honda VF700, VF750 and VF1000 Intercepter without a doubt. Clymer manuals provide clear and detailed step-by-step instructions with helpful diagrams and photos to help you succeed. From simple mainteance tasks to full engine rebuilds, you will find the help you are looking for to save money by avoiding the high fees at your Honda service dealer.

Subject: 1983, 1984, 1985 Honda VF700, VF750, VF1000 Interceptor service, maintenance, and repair procedures. ISBN-10: 0892875194 | ISBN-13: 9780892875191 | Clymer M349
TABLE of CONTENTS:
  • Quick Reference Data
  • General Information
  • Troubleshooting
  • Lubrication, Maintenance and Tune-up
  • Engine
  • Clutch and Transmission
  • Fuel and Exhaust Systems
  • Ignition System
  • Front Suspension and Steering
  • Rear Suspension
  • Brakes
  • Body and Frame
  • Wiring Diagrams

Specifications

  • Publisher: Clymer Series / Haynes Manuals
  • Pages: 412 - Hundreds of b&w photos and illustrations
  • Binding: Paperback - 7 x 10 inches
  • ISBN: 978-0-89287-519-1
  • Years: 1983 - 1985