The International Harvester Tractor Repair Manual Series A, B, C, MTA, H, M, MD, Cub, more... covers tractor models indicated:
Super and Non-Super Series
- A, B, C
- MTA, H, M, MD
- Cub (prior to 1957)
- 4, 6, D6
- W6TA, W6TAD
- 9, D9
Note: This tractor repair manual DOES NOT include wiring diagrams.
Book Excerpt: International Harvester Tractor Repair Manual Series A, B, C, MTA, H, M, MD, Cub, more...
AXLE MAIN MEMBER
MAIN DRIVE BEVEL GEARS AND DIFFERENTIAL
3. The A, Super A and Cub axle main member pivots on shaft (26- Fig. IH302) which is retained in the axle mounting bracket (steering gear housing base) by clamp bolts.
The AV and Super AV axle main member pivots on a shaft which passes through the steering gear housing base and extends rearward where the shaft bushings (21) which are pressed into the axle main member can be renewed after removing the axle main member from tractor.
The C and Super C front axle main member pivots on shaft (26) which is retained in the axle mounting bracket (41) by pin (40).
Three pre-sized bushings (21) which are pressed into the axle main member and integral stay rod, can be renewed after removing the axle main member from tractor.
4. On adjustable axle models shown in Figs. IH304, 305A and 305B, the center member pivots on pin (21) which is pinned in the adapter or lower bolster (19).
Two pivot pin bushings (12) which are passed into the center member, should be reamed after installation to provide a pin to bushing clearance of 0.003-0.006.
On non-adjustable axle models, the unbushed main member pivots on pin (24-Fig. IH305) or (10 - Fig.IH306). Excessive clearance between axle and pivot pin is corrected by renewing the worn part.
ADJUST BEVEL GEARS - All Models
300. The tooth contact (mesh pattern) and backlash of the main drive bevel gears is controlled by shims on all models.
Tooth contact (mesh pattern) and backlash should be checked and adjusted, if necessary, whenever the transmission is being overhauled, and always when a new pinion or ring gear, or both, are installed.
This I&T/Clymer IH International Harvester Shop Manual is a concise, well written and point on repair manual that is much more comprehensive in its coverage than its appearance. This manual will surely help you do your own repairs so you can save your hard earned money for something you really need - other than a mechanic's big bill.
Subject: International Harvester farm tractor service, maintenance, and repair instructions.
ISBN-10: 0872881016 | ISBN-13: 9780872881013