Chevrolet Camaro Berlinetta, RS, Z28 Repair Manual 1982-1992

• Camaro Sport Coupe, 1982-1992
• Camaro Berlinetta, 1982-1992
• Camaro RS Rally Sport, 1982-1992
• Camaro Z28, 1982-1992

PUSHROD SIDE COVER | REMOVAL AND INSTALLATION

2.5L ENGINE
(See Figure 23)

1. Disconnect the negative battery cable.



2. Mark and remove the distributor assembly.



3. Remove the ignition coil and bracket.



4. Remove the side cover retaining nuts and remove the cover.


INSTALLATION


5. Clean the cover sealing surfaces of all RTV or gasket material.



6. Place a 1/16 in. (5mm) bead of RTV sealant all around the rocker arm sealing surface or use a cork style gasket. (When going around the attaching bolt holes, always flow the RTV on the inboard side of the holes).



7. Install cover and torque bolts to 89 inch lbs. (10 Nm).



8. Finish installation by reversing removal procedure.

REMOVAL AND INSTALLATION
(See Figures 29, 30, 31, 32 and 33)

NOTE: Some of the following cables will not be used on all models and model years.

LEFT AND RIGHT AIR VENT CABLES

1. Remove the left and right sound insulators.



2. Remove the screws attaching the cables to the steering column cover.



3. Disengage the cable clamps at the vent ducts.



4. Disengage the Z-shaped cable ends from the vent valve levers.



5. Remove the air vent cables noting their positions for installation.


INSTALLATION


6. Place the cables in position under the instrument panel.



7. Engage the Z-shaped cable ends to the vent valve levers.



8. Snap the cable clamps into the slot of the bracket formed on the vent ducts.



9. Attach the air vent cables at the steering column cover.



10. Install the sound insulators and test cable operation.

VENT CONTROL CABLE

1. Remove the right side sound insulator.



2. Remove the push nut retainer holding the cable self-adjusting clip to the vent valve lever pin.



3. Disengage the cable clamp from the slot in the bracket on the heater module.

• Tune-up and routine maintenance
• 2.5L TBI inline 4-cylinder engine
• 2.8L Carb./MPI V6 engine
• 3.1L MPI V6 engine
• 5.0L Carb./TPI/EFI V8 engine
• 5.7L TPI V8 engine
• Engine and overhaul procedures
• Cooling, heating and air-conditioning systems
• Fuel and exhaust systems
• Engine electrical systems
• Emissions control systems
• Manual transmission
• Clutch
• Automatic transmission
• Brakes
• Suspension and steering systems
• Body
• Chassis electrical system
• Wiring diagrams