* Early models 191000 and 193000 had a cast-iron crankcase with different specifications not covered in this manual.
TABLE of CONTENTS:
QUICK REFERENCE DATA
CHAPTER ONE: GENERAL INFORMATION
Safety | Notes, cautions and warnings | Service hints | Special tools | Basic hand tools | Test equipment | Precision measuring tools | Fasteners | Sealants, cements and cleaners | Lubricants.
CHAPTER TWO: ENGINE FUNDAMENTALS
Operating principles | Major engine components | Fuel system | Ignition system | Electrical system.
CHAPTER THREE: GENERAL ENGINE INFORMATION
Fuel | Oil | Engine identification | Basic engine specifications | Purchasing parts.
CHAPTER FOUR: TROUBLESHOOTING
Operating requirements | Troubleshooting.
CHAPTER FIVE: LUBRICATION and MAINTENANCE
Lubrication | Maintenance | Carburetor | Combustion chamber.
CHAPTER SIX: FUEL and GOVERNOR SYSTEMS
Operating linkage | Carburetors | Governor system.
CHAPTER SEVEN: IGNITION SYSTEM and FLYWHEEL BRAKE
Ignition coil | Ignition module | Stop switch | Flywheel brake.
CHAPTER EIGHT: REWIND STARTERS
Rewind starters mounted on blower housing (except Quantum engines) | Vertical-pull rewind starter | Quantum 100000 series rewind starter | Quantum 121000, 122000, 124000 and 126000 series rewind starters.
CHAPTER NINE: ELECTRICAL SYSTEM
Testing | Battery | Charging/lighting system | Electric starter system | Electric starter motors.
CHAPTER TEN: GENERAL INSPECTION and REPAIR TECHNIQUES
Failure analysis | Precision measurements | Repair techniques.
CHAPTER ELEVEN: ENGINE OVERHAUL
Muffler | Crankcase breather | Flywheel | Cylinder head | Valve system | Oil seals (service with crankshaft installed) | Internal engine components | Engine disassembly | Piston, piston rings and piston pin | Connecting rod | Camshaft and tappets | Governor | Crankshaft and main bearings | Cylinder | Oil seals | Oscillating balancer | Rotating counterbalance system | Breaker-point plunger hole | Engine reassembly.
CHAPTER TWELVE: BRIGGS and STRATTON TOOLS
Carburetor nozzle screwdriver | Flywheel brake band adjustment gauge | Flywheel holder | Fuel mixture adjusting screwdriver | Tang bender | Valve lapping tool, and many more with BandS tool numbers.